Certificates, test and analysis reports for our products and company. Each card shows the issuing body, document number and date.
Documented assurance
5 documents name the issuing body
3 documents carry a verifiable certificate / report number
A test or analysis report is the measured result of a specific sample by a specific method; it does not replace a certificate.
All documents
All 5
Copy available on request
Certificate Manufacturer's document
E190 cold-rolled square section inspection certificate (EN 10204 3.1)
Chemical analysis, tensile strength (332–366 N/mm²), yield and elongation values for batches of E190 grade cold-rolled square section (20x20x2 and 40x40x1.5 mm). The non-destructive testing result is 'OK'.
This document belongs to the manufacturer of the product we use.
Method / standard
EN 10204 type 3.1; dimensional check TS EN 10305-3:2024
S235JRH steel box and pipe section factory test certificate (EN 10204 2.2)
Chemical analysis and tensile/yield/elongation values for batches of S235JRH grade hot-rolled box section (40x20x1.5; 40x20x2; 60x40x2; 80x40x2 mm) and pipe (139.7x3; 219.1x3 mm). Tensile strength is 366–422 N/mm².
This document belongs to the manufacturer of the product we use.
Method / standard
EN 10204 type 2.2; dimensional check TS EN 10219-1:2008
DIN 4102-1 B2 flammability class test report (PVC tarpaulin, 280–1100 g/m²)
In edge and surface ignition tests, the yellow PVC tarpaulin sample (280–1100 g/m²) declared by the manufacturer did not reach the flame reference line and produced no burning droplets. The material was classified as DIN 4102-1 B2 (result: Pass).
This document belongs to the manufacturer of the product we use.
Method / standard
DIN 4102-1:1998 (sections 6.2.1 and 6.2.5, edge and surface ignition)
Values declared by the manufacturer for its 1100 dtex woven polyester, PVC-coated 650 g/m² (±15) tarpaulin: breaking strength 2100 N, tear strength 210 N (weft/warp), 10,000 mm water column, resistance from −30 to +70 °C, colour fastness 6–7, phthalates below 1000 ppm; width 150–320 cm.
This document belongs to the manufacturer of the product we use.
Method / standard
TS EN ISO 1421 (breaking strength), TS EN ISO 4674-1 Method A (tear strength), TS EN ISO 105-B04 (colour fastness), EN 14372:2004 (phthalates)
ABA aluminium-bubble thermal insulation film technical datasheet
Manufacturer values for a 4 mm LDPE bubble insulation film with aluminium foil on both faces: 200 ± 5 g/m², thermal conductivity 0.036 W/mK (in-house method), reflectance 0.97, emissivity 0.03, service temperature 10–82 °C.
This document belongs to the manufacturer of the product we use.
Method / standard
ASTM C411, ASTM C1371, ASTM E903, ASTM D374 and the manufacturer's in-house methods
